44| Customizing the Sound sets
2 Use the Type parameter to choose an Ensemble type.
Ensemble type How it works [Meaning]
Duet Adds a single note to the melody.
Close Adds a closed-position chord to the melody.
Open 1 Adds an open-position chord to the melody.
Open 2 As the above, but with a different chord shape.
Block Block harmonization – very typical of jazz music.
Power Ensemble Adds a fth and an octave to the melody, as heard in hard rock.
Third Up This option adds a third over the melody note (depending on the
recognized chord).
Fourths LO Typical of jazz, this option adds two perfect fourths under the melo-
dy.
Fourths UP As the above, but with notes added over the melody.
Fifths This adds two fths below the original note.
Octave Adds an octave to the melody.
Dual This option adds to the melody line a second note, at a xed interval
set with the “Note” parameter. When selecting this option, a transpo-
sition value appears (-24...+24 semitones to the original note).
Brass Typical Brass section harmonization.
Reed Typical Reed section harmonization.
Trill When two notes are played on the keyboard, this option trills them. If
three or more notes are played, only the last two are trilled. You can
set the trill speed by using the Tempo parameter (see below).
Repeat The played note is repeated in sync with the Tempo parameter (see
below). When playing a chord, only the last note is repeated.
Echo As the Repeat option, but with the repeated notes fading away after
the time set with the Feedback parameter (see below).
AutoSplit1 If more than a single Upper track is in play, the Upper 1 track plays
the melody in mono, while the other Upper tracks play the chord
notes.
If only the Upper 1 track is in play, it plays poly- phonically all the
chord notes.
AutoSplit2 Similar to AutoSplit1, but the Upper 1 track always plays the upper-
most note.
3 If they appear, adjust the additional parameters.
Additional
parameters
How it works Value
Note Velocity Velocity (dynamics) difference between the melody played
with your right-hand and the added harmonization notes.
-10…0
Tempo Note duration for the Trill, Repeat or Echo Ensemble options.
This is in sync with the Metronome Tempo.
Feedback Repetitions of the original note/chord when the Echo option
is selected.
[n]
To Next Page
Loading...
Need help?
General
