Introduction to the KROSS
8
h: Check box
By selecting a check box parameter and pressing the ENTER
button or turning the value dial, you can select or clear the
check box.
You can enable or disable a parameter or function by
selecting or clearing the check box. The parameter or
function is enabled if the check box is selected, and disabled
if it is cleared.
i: Category select icon
For parameters indicated by this icon, you can use the
CATEGORY dial or the SELECT dial to select the category
or number.
j: Scroll
Use this to see parameter values that cannot be shown in a
single screen. Additional parameters exist in the direction of
the black indicator.
k: Function list
The function list will appear when you press the
FUNCTION button. The functions that are shown will
depend on the page that’s selected.
The functions shown on the bottom of the dialog box are
assigned to the four buttons. (see page 3)
l: Function dialog box
When you select a function, you’ll see a dialog box where
you can adjust the settings that are needed to execute the
command. The dialog box that appears will depend on the
command that you selected. Some commands such as Solo
Setting do not display a dialog box.
* Text edit
When you select a parameter indicated by this icon and press
the ENTER button, a text edit window will appear.
In this screen you can rename text (such as the name of a
program, combination, or song). (see “Editing names” on
page 105)
* OK (MENU) button, CANCEL (FUNCTION) button
To execute a function, press the OK button. To cancel
without executing, press the CANCEL button.
* Done button, Copy button, Insert button
There are also buttons such as Done, Copy, and Insert which
perform an action when pressed, like the OK button and
CANCEL button explained in “* Function dialog box.”
j: Scroll
k: Function list
l: Function dialog box
Text edit icon
CANCEL (FUNCTION) button OK (MENU) button
To Next Page
Loading...
Need help?
General
