Korg minilogue - Amplifier Envelope Generator (AMP EG); AMP EG Parameters

19
VELOCITY switch [0%, 50%, 100%]
Species how the velocity (keyboard playing dynamics) will aect the cuto
frequency, allowing louder notes to appear brighter, etc.
0% (lower position): Velocity will not aect the cuto frequency.
50% (center position): Velocity will aect the cuto frequency, but at only half
the amount produced at 100%.
100% (upper position): Playing the keys harder will increase the cuto frequen-
cy, while playing the keys softer will decrease the cuto frequency.
AMP EG
VCA: Voltage Controlled Amplier / EG: Envelope Generator
The AMP (VCA) controls the output level of
the minilogue, before the Master control. The
AMP Envelope Generator provides a precise
control signal that varies over time to modify
the VCA level.
ATTACK knob [0...1023]
The ATTACK species the time required for the EG to reach its maximum level
once a new note is played
DECAY knob [0...1023]
The DECAY species the time required for the EG to fall to the preset Sustain
level once the Aack portion of the EG is complete.
SUSTAIN knob [0...1023]
The SUSTAIN species the level that will be maintained while the key is held
down (or a trigger is applied).
RELEASE knob [0...1023]
The RELEASE species the time required for the EG to reach its minimum level
(zero) once the key or trigger is released.
0
Attack Level
Time
Note on Note o
Level
Sustain
Level
Attack
Time
Decay
Time
Release
Time