Korg minilogue - Sequencer Clear Functions

38
Default Gate Time [0–100%]
The Gate Time is the default value used for each step recorded using the Step
Sequencer. Lower values are more staccato, higher values have a longer gate
time.
Button 3 (SEQ CLEAR)
This function provides a convenient way to erase all data within a specic se-
quence.
All Clear
When using All Clear, all notes and Motion Sequences contained within the
sequence data will be deleted.
Turn the PROGRAM/VALUE knob until “Press WRITE” is indicated in the dis-
play. The WRITE buon will blink.
Press the WRITE buon to delete the data. The display will indicate the mes-
sage “All Cleared”.
Motion Clear
With Motion Clear, only the Motion Sequences contained within the sequence
data will be deleted.
Turn the PROGRAM/VALUE knob until “Press WRITE” is indicated in the dis-
play. The WRITE buon will blink.
Press the WRITE buon to delete all of the Motion Sequence data. The display
will indicate the message “Motion Cleared”.
Button 4 (MOTION CLEAR)
MOTION CLEAR
Unlike the previous motion clear, Buon 4 allows you to clear motions 1–4 in-
dividually.
Press buon 4 to select the Motion Sequence to delete.
Turn the PROGRAM/VALUE knob until “CLEAR...?” is indicated in the dis-
play. The WRITE buon will blink.
Press the WRITE buon to delete the data. The display will indicate the mes-
sage “Cleared”.
TIP
While the SHIFT buon is pressed, the MOTION VIEW screen will
be displayed, where you can see the waveforms for the Motion Se-
quences you have recorded. This will not be displayed if a Motion
Sequence has not been recorded yet.