EasyManuals Logo

Korg PA600 Reference Guide

Korg PA600
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #305 background imageLoading...
Page #305 background image
301
Effects
Mono-Mono Serial (Mono-Mono)
Appendix
103: Wah - Amp Sim
(Wah - Amp Simulation)
This effect combines a mono wah and an amp simulation. You
can change the order of the effects.
104: Decimator - Amp
(Decimator - Amp Simulation)
This effect combines a mono decimator and an amp simulation.
You can change the order of the effects.
WAH
a
[W]
Frequency
Bottom
0...100
Sets the lower limit of the wah
center frequency
Frequency Top 0...100
Sets the upper limit of the wah
center frequency
b
[W]Sweep
Mode
Auto,
D-mod,
LFO
Selects the control from auto-wah,
modulation source, and LFO
Src Off...Tempo
Selects the modulation source for
the wah when Sweep Mode=D-mod
c
[W]LFO
Frequency [Hz]
0.02...20.00 Sets the speed of the LFO
Resonance 0...100 Sets the resonance amount
LPF Off, On
Switches the wah low pass filter on
and off
d
[W]Wet/Dry
Dry, 1:99...99:1,
Wet
Sets the wah effect balance
Src Off...Tempo
Selects the Wet/Dry modulation
source for the wah
Amt –100...+100
Sets the Wet/Dry modulation
amount for the wah
AMP SIM
e
[A]Amplifier
Type
SS, EL84, 6L6 Selects the type of guitar amplifier
fRouting
Wah
Amp,
Amp
Wah
Switches the order of the wah and
amp simulation
g
Wet/Dry
Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 243
Amt –100...+100 Amount of modulation source
FX Amt
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Amp Simulation
Amp Simulation Filter
Wah/Auto Wah
Wah
D
-mod
Envelope
Sweep Mode
D-mod
Auto
LFO
LFO
DECIMATOR
a
[D]Pre LPF Off, On
Turn the harmonic noise caused by
lowered sampling on and off
High Damp
[%]
0...100 Sets the ratio of high-range damping
b
[D]Sampling
Freq [Hz]
1.00k...48.00k
Sets the sampling frequency
Resolution 4...24 Sets the data bit length
c
[D]Output
Level
0...100 Sets the decimator output level
AMP SIM
d
[A]Amplifier
Type
SS, EL84, 6L6 Selects the type of guitar amplifier
eRouting
Decimator
Amp, Amp
Decimator
Switches the order of the decimator and
amp simulation
f
Wet/Dry
Dry,
1:99...99:1,
Wet
Balance between the wet and dry signal
Src Off...Tempo
Table ,Dynamic Modulation sources,”
on page 243
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Decimator
Routing
Amp Simulation
Amp Simulation Filter
Pre LPF
High Damp
Output Level
Decimator
Resolution

Table of Contents

Other manuals for Korg PA600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Korg PA600 and is the answer not in the manual?

Korg PA600 Specifications

General IconGeneral
BrandKorg
ModelPA600
CategorySynthesizer
LanguageEnglish

Related product manuals