302
Effects
Mono-Mono Serial (Mono-Mono)
105: Decimator - Comp
(Decimator - Compressor)
This effect combines a mono decimator and a compressor. You
can change the order of the effects.
106: AmpSim - Tremolo
(Amp Simulation- Tremolo)
This effect combines a mono amp simulation and a tremolo.
DECIMATOR
a
[D]Pre LPF Off, On
Turn the harmonic noise caused by
lowered sampling on and off
High Damp [%] 0...100
Sets the ratio of high-range
damping
b
[D]Sampling
Freq [Hz]
1.00k...48.00k
Sets the sampling frequency
Resolution 4...24 Sets the data bit length
c
[D]Output
Level
0...100 Sets the decimator output level
COMPRESSOR
d
[C]
Sensitivity
1...100 Sets the sensitivity
e
[C]Attack 1...100 Sets the attack level
Output Level 0...100 Sets the compressor output level
fRouting
Decimator
Comp,
Comp
Decimator
Switches the order of the decimator
and compressor
g
Wet/Dry
Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 243
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Decimator
Routing
Pre LPF
High Damp
Output Level
Decimator
Resolution
Compressor
Comp
Output Level
Envelope - Control
AMP SIM
a
[A]Amplifier
Type
SS, EL84, 6L6 Selects the type of guitar amplifier
TREMOLO
b
[T]LFO
Waveform
Triangle, Sine,
Vintage, Up,
Down
Selects the LFO Waveform
LFO Shape –100...+100
Changes the curvature of the LFO
Waveform
c
[T]LFO
Frequency [Hz]
0.02...20.00 Sets the speed of the LFO
d [T]Depth 0...100 Sets the depth of LFO modulation
e
Wet/Dry
Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 243
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Amp Simulation Tremolo
Amp Simulation Filter
Tremolo
LFO: Tri/Sin/Vintage/Up/Down
LFO Shape
To Next Page
Loading...
Need help?
General
