Korg prologue - Page 40

40
Setting the timbre parameters
Youcanalsousesplit,crossfadeorlayeringwhenplayingtwotimbres,aswellas
adjust their volume balance.
prologue-16
1.
Use the knobs and switches on the front panel to set the timbre parameters.
Adjustthevolume balance between the main timbre and the sub-timbre using
the MAIN/SUB BALANCE knob.Fordetails,referto“MAIN/SUBBALANCE
knob(prologue-16only)”(p.22).
Use the TYPE switch to set the timbre performance type (layer, crossfade or
split).Fordetails,referto“TYPEswitch(prologue-16only)”(p.22).
Set the timbre position and split point(whenplayinginsplitmode)in“Timbre,”
PROGRAMEDITmode.Referto“Button3(TIMBRE)”(p.46) for details.
Set the timbre to edit using the PANEL switch.
TIP
Editing a timbre applies to the basic parameters on the front panel, as well
asalldetailedparametersinPROGRAMEDITmode.
prologue-8
1.
Press the EDIT MODE buon.
The instrument will enter Edit mode.
2.
Turn the PROGRAM/VALUE knob or press the EDIT MODE buon, and se-
lect PROGRAM EDIT.
3.
Press buon 3 several times.
Each parameter related to the timbre is shown on the display.
Referto“Button3(TIMBRE)”(p.46) for details on each parameter.
4.
Turn the PROGRAM/VALUE knob to change the seings.
5.
Press the EXIT buon.