Korg prologue - Page 49

49
Button 6 (OTHER SETTINGS)
Arpeggiator [Main+Sub, Main, Sub]
Sets the timbre(s) that will be played by the arpeggiator.
When this is set to “Main+Sub”, both timbres will sound. When this is set to “Main”,
thearpeggiatorwillplayonlythemaintimbre;andwhenthisissetto“Sub”, only
the sub-timbre will sound.
Multi Routing [Pre VCF, Post VCF]
ThissetswhethertheMULTIENGINEismixedpriortothesignalreachingtheVCF,
orwhethertobypasstheVCFandmix.
When this is set to “PostVCF,”theVCFwillnotaecttheMULTIENGINE.
EG Legato [O, On]
When the voice mode is set to “Mono”,“Unison”or“Chord,” this sets what hap-
pens with the EG when a key is played in legato while another key is being pressed.
O: The EG will be retriggered.
On: The EG will not be retriggered.
Portamento Mode [Auto, On]
Auto: When playing in a legato style (playing a new note before any previously
played note is released), portamento will be applied.
On: Portamento will be applied, even when fully releasing a key and then playing
the next note.
Voice Spread [0...127]
Thisadjuststheamountofvoicespreadthatisappliedtoachieveastereoeect.
Thehigherthevalue,thestrongerthevoicespreadeectwillbe.
Program Level [-18.0dB...+6.0dB]
Program Level allows you to adjust the volume of a Program relative to other Pro-
grams.
Increasing this value will make the volume louder.