29
Global mode
8. MIDI RESET (Transmit messages for MIDI reset)
This function allows you to transmit messages to reset the MIDI settings of an external device connected to
the SGproX’s MIDI OUT.
Press the 〈+1/YES〉 switch and you will be asked “Are You Sure OK”? Press 〈+1/YES〉 again, and the
following MIDI messages will be transmitted, and the display will indicate “Completed.”
Message contents
All Notes Off for all channels
Note Off for all channels
Hold (Damper) Off for all channels
Sostenuto Off for all channels
Reset All Controllers for all channels
9. CONTROLLER (Controller settings)
These settings specify the function that each controller will have in Program mode. (These settings are
shared by all programs.)
Assignable wheels/switches 〈AW1〉 〈AW2〉
Assignable sliders/switches 〈AL1〉 〈AL2〉 〈AL3〉 〈AL4〉
Assignable pedal (AP)
Assignable switch (AS)
Functions can be assigned independently to each of the above
eight controllers.
Depending on the type of controller, there are some restric-
tions on the function which can be selected. Refer to Controllers / MIDI (
p.55).
When you move from Performance mode into Global mode, the operation and sound will be the same as in Perfor-
mance mode. If you wish to verify the operation of the controllers as you make settings, you will need to enter
Global mode from Program mode.
10. VEL. CURVE (Velocity curve settings)
These settings specify how the force with which you play the keyboard will be applied to the volume or tone.
These settings will affect the way in which the internal tone generator will sound, and will also affect
transmission of MIDI Note On messages. However, they will not affect MIDI reception.
The velocity curve is determined by the minimum (p) and maximum (f) velocity values, and by the shape of
the curve (Fig.) that connects these two points. With an (f) setting of 150, a velocity of 127 (the maximum
for MIDI) will be transmitted even when you do not play very hard.
VEL. FIGURE
1: Significant effect will not occur for medium-strength
notes.
2: Standard curve
3: Substantial effect will occur even for medium-strength
notes.
4: There will be little change for medium-strength notes,
and the effect will be fairly even.
Range of settings 1 to 4
Factory setting 2
High
Velocity value
Keyboard playing strength
Strong
Soft
VEL. FIGURE
1
2
4
3
Low
MIN
MAX
Example of VEL. CURVE settings
Fig=4, p=10, f=140
127
(p) 10
(f) 140
Velocity
Keyboard playing strength
Strong
Soft
To Next Page
Loading...
Need help?
General
