Korg wavestate native - Automation and Data Management; Copy and Paste Functionality; Copy;Paste for Wave Sequence Steps

Getting Started
15
Automation
Automation from the plug-in host is supported for most, but not all, modulatable parameters. Even if a parameter is not
directly available for automation, you may be able to create a modulation routing from a Mod Knob or Eect Edit knob,
and then modulate the knob. Most non-modulatable parameters cannot be automated, including modulation routings
themselves (sources and intensities), lter and mod processor types, Multisample selection, and so on.
For Eects, only controls shown in the “Mini Editors” can be automated. is includes Edit 1/2/3, Wet/Dry, and level
controls. For individual Wave Sequence Steps steps, automatable parameters include Timing Lane Duration, Pitch
Lane Transpose, Shape, Gate Length, and Step Seq Value.
Copy/Paste
You can use copy/paste with:
• Layers
• Programs
• LFOs
• Envelopes
• Vector Envelope
• Filter & Amp Key Track
• Mod Processors
• Individual eects (Pre FX, Mod FX, Delay, Reverb, and Master EQ)
• Filter settings
• Arpeggiator settings
• Wave Sequence Steps
For example, you can copy from one LFO to another in the same Program, or copy the Filter or Arpeggiator settings
from one Layer to another.
Using Copy/Paste
To use copy and paste with anything other than Wave Sequence Steps:
1. Right-click (or control-click on MacOS) on the title of the section that you’d like to copy, such as Filter LFO,
Arpeggiator, or Mod Processor 2.
A contextual menu will appear.
2. Select Copy from the contextual menu.
3. Right-click (or control-click on MacOS) on the title of the section to which you’d like to Paste.
Note that this has to be the same type as the copy source; for instance, you can’t copy an LFO to an Envelope.
4. Select Paste from the contextual menu.
Copy/Paste for Wave Sequence Steps
Wave Sequence Steps support Copy and Paste, as well as Cut, Insert Before, Insert Aer, and Delete. Shi-click to
select a range of Steps, or select multiple non-continuous items by holding down the Command key on MacOS, or the
Ctrl key in Windows. Once you’ve selected the desired step(s), right-click (or control-click on MacOS) to bring up the
contextual menu and choose the desired copy/paste operation. For details, see “Wave Sequence Steps contextual menu”
on page39.