Korg wavestate native - Program Setup; Voice Allocation

Setup page
42
Program Setup
Volume
[-Inf, -84.9…0.0 dB]
is controls the overall volume of the Program, for volume-balancing with other sounds.
Transpose
[-60…+60 semitones]
is transposes the Program by up to +/- ve octaves, in semitones.
Random Pitch Range
[0.0…50.0 cents]
is parameter creates random variations in pitch for each note. At the default of 0.0, pitch will be completely stable;
higher values create more randomization. is can be helpful for simulating instruments that have natural pitch
instabilities, such as analog synths, tape-loop keyboards, or acoustic instruments.
Trigger & Hold
Trigger On
[Key-On, Key-O]
Key-On: is is the default setting, in which the Program is played when a key is pressed.
Key-O: e Program will play as soon as you release the key. You can use this to create the “click” heard when a
harpsichord note is released, for instance. In general, when using Key-O it’s also best to set the Amp Envelope Sustain
to 0.
Hold
[O, On]
Hold is like permanently pressing down on the sustain pedal. Notes continue to play as if you were holding down the
key—even aer you li your ngers from the keyboard. If the sound is a looped Wave Sequence or a looped single
sample, it will play continuously until you select a dierent sound.
O: Notes will play normally. is is the default setting.
On: e sound will hold indenitely.
Important: is older Program-level Hold setting is largely superseded by Performance Hold. For details, see
“8: Perf. Hold (Performance Hold)” on page 4.
Voice Allocation
Mode = Poly
(Voice Assign) Mode
[Poly, Mono]
is selects the basic voice allocation mode. Depending on which one you select, various other options will appear,
such as Single Trig (Poly mode only) and Unison (Mono mode only).
Poly: e Program will play polyphonically, allowing you play chords.
Mono: e Program will play monophonically, producing only one note at a time.
Single Trigger
[O, On]
Single Trigger is available when Voice Assign Mode is set to Poly.
On: When you play the same note repeatedly, the previous note will be silenced before the next note is sounded, so that
the two do not overlap.
O: When you play the same note repeatedly, the notes will overlap.