Korg wavestate native - Zones and Scales; Keyboard Zone Setup; Velocity Zone Configuration; Performance Pitch and Scale

Zones & Scales page
47
Zones & Scales page
Keyboard Zones
High (A…D), Low (A…D)
[C-1…G9]
ese set the highest and lowest notes on which the Layer will sound.
Note: e graphic shows only the standard range of 88 notes.
HFade (High Fade A…D)
[0…127]
0: e High key acts as a hard split, with full volume on one side and silence on the other.
1…127: is allows you to create a keyboard crossfade. As the notes approach the High key, the volume will fade out
gradually. is sets the number of semitones over which the fade-out occurs, working inwards from the High key.
To edit Fade ranges in the Zone graphics, use Option-drag (macOS) or Alt-drag (Windows).
LFade (Low Fade A…D)
[0…127]
See “HFade (High Fade A…D),” above.
Velocity Zones
High Vel (A…D), Low Vel (A…D)
[1…127]
ese set the highest and lowest velocities on which the Layer will sound.
High Fade (A…D)
[0…126]
0: e High Vel acts as a hard split, with full volume on one side and silence on the other.
1…126: is lets you create a velocity crossfade. As velocity approaches the High Vel, the volume fades out gradually.
High Fade sets the velocity range over which the fade-out occurs, working inwards from the High Vel.
Low Fade (A…D)
See “High Fade (A…D),” above.
Performance Pitch & Scale
Octave
[-2…+2]
is transposes the entire Performance by 2 octaves, up or down.
Transpose
[-12…+12]
is transposes the entire Performance by 12 semitones, up or down.
Use Perf Scale
[O, On]
On: e Performance Scale settings, below, are used—unless Global Scale is On, in which case the Global scales are
used instead. See “Global Scale” on page 11.
O: e Performance Scale settings are ignored.