EasyManua.ls Logo

Korg wavestate native - Sample Lane and Pitch Lane

Korg wavestate native
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Wave Sequencing 2.0
30
Sync Notes
A1 A2 A3 A4 A5 A6 A7 A8 A9
A10 A11 A12
A1 A2 A3 A4 A5 A1 A2 A3 A4 A5 A1 A2
Timing Lane
Sample Lane
A1 A2 A3 A4 A2 A3 A4 A2 A3 A4 A2 A3Step Seq Lane
A7 A8 A9
A10 A11 A12
A2 A3 A4 A5 A1 A2
Timing Lane
Sample Lane
A4 A2 A3 A4 A2 A3Step Seq Lane
Sounding Note
New Note
Mode = Single Multisample
(Multisample)
[List of Multisamples]
is selects the Multisample for the Step. Use the < and > arrows to step through Multisamples one by one, or click on
the name to bring up a browser window.
Start Oset
[O, 1st…8th]
In addition to simply starting playback from the beginning, Multisamples may have up to 8 dierent pre-programmed
alternate starting points, or “Start Osets.” ese skip part of the beginning of the samples, either to make them more
gentle (for percussive sounds) or to make them start more quickly (for sounds with slow attacks). e number of
available osets will vary depending on the specic Multisample.
If no alternate start points are available, this will show n/a.
Channel
[Stereo, Left, Right, n/a]
is applies to stereo Multisamples only; for mono Multisamples, “n/a” is shown. You can choose whether to use the
original Stereo signal, or only the Le or Right channels (in mono).
Standard Lane Controls
ese controls apply to all lanes except Master. (Master still has Presets, however.) Some Lanes have special parameters
in addition to the standard controls, as described in the following sections.
Lane Preset
Lane Presets store all of the parameters for the Lane and its Steps. Explore the system by mixing and matching presets
for dierent Lanes.

Related product manuals