Korg wavestate native - Layer Setup

Setup page
44
Voices Detune
3 +4
4 +12
Thickness
[0…100]
is parameter controls the character of the detuning for the unison voices.
0: Unison voices are evenly distributed across the Detune range, as shown above.
1…100: Unison voices are detuned asymmetrically. is makes the detuning more complex, and changes the way
in which the pitches beat against one another—like slightly out-of-tune oscillators in a vintage synthesizer. Higher
numbers increase the eect.
Stereo (Spread)
[0…100]
Stereo lets you create a wider stereo eld when using Unison. It applies only when Unison Voices is 2 or greater.
Layer Setup
Pitch
Octave
[-3…+3]
is transposes the Layer by 3 octaves, up or down.
Tune
[-100…+100 cents]
is lets you detune the Layer by up to 100 cents (1/100 of a semitone), up or down.
MIDI
Use Global MIDI Channel
[O, On]
On: is is the default. e Layer will receive on the Global Channel.
O: e Layer will receive on the channel specied below.
MIDI Channel
[1…16]
is is shown only if Use Global MIDI Channel is O. It sets the channel on which the Layer will receive MIDI.
Rx Damper
[O, On]
On: is is the default. e Layer will respond to MIDI CC#64.
O: e Layer will ignore MIDI CC#64.
Rx Other CCs
[O, On]
On: is is the default. e Layer will respond normally to MIDI CCs.
O: e Layer will ignore all MIDI CCs (except for CC#64), as well as Aertouch, Poly Aertouch, and Pitch Bend.