Korg wavestate native - Xfade, Sample, and Pitch Lanes; Xfade Time and Shape; Sample Lane Function; Pitch Lane Interaction

Wave Sequencing 2.0
34
Xfade
[Time: 0.0000…10.0000 seconds]
[Tempo: List of rhythmic values]
If Timing Lane Xfade is set to Time, you can set the length of the crossfade in seconds.
If Timing Lane Xfade is set to Tempo, you can set the basic length of the crossfade as a rhythmic value, relative to the
system tempo. e values range from a 32nd note to a double breve (four whole notes), including dotted notes and
triplets.
x (Multiply Base Note by…)
[1…32]
is appears if Timing Lane Xfade is set to Tempo. It multiplies the length of the Xfade Base Note.
Fade-In (Fade-In Shape)
[Log, -99…-1, Linear, +1…+99, Exp]
is sets the shape for the next step’s fade-in within the crossfade.
Log: the step will fade in quickly at rst, and then move more slowly as it nears the end of the crossfade. To create an
equal-power crossfade, use Log for both Fade-In and Out.
Linear: the step will fade in steadily over the duration of the crossfade.
Exp: the step will fade in slowly at rst, and then move more rapidly as it nears end of the crossfade.
Fade-Out (Fade-Out Shape)
[Log, -99…-1, Linear, +1…+99, Exp]
is sets the shape for the current step’s fade-out within the crossfade.
Log: the step will fade out slowly at rst, and then move more rapidly as it approaches the end of the crossfade.
Linear: the step will fade out steadily over the duration of the crossfade.
Exp: the step will fade out quickly at rst, and then move more slowly as it nears the end of the crossfade.
Sample
is Lane sets the sample played by each Step.
Sample Lane
Preset, Start, End, Loop Start, Loop End, Repeats
See “Standard Lane Controls” on page 30.
Pitch Lane
[Only Aects Pitch, Aects Sample Map]
Multisamples typically include many dierent samples, mapped across the keyboard. When you transpose the
keyboard, for instance, it’s not just the pitch that changes; dierent samples will be selected as well. Sometimes, you may
want the Pitch Lane to aect sample choice, as if you were transposing the keyboard; other times, you may want it to
only change the pitch, without aecting the sample choice. is parameter lets you choose between the two options.
Only Aects Pitch: e Pitch Lane only aects the played pitch; it will not change the sample chosen by a given key.
Aects Sample Map: e Pitch Lane will act similar to transposing the keyboard, and may select dierent samples
according to the selected Multisample.
Sample Lane Step
Channel
[Stereo, Left, Right, n/a]
is applies to stereo Multisamples only; for mono Multisamples, “n/a” is shown. You can choose whether to use the
original Stereo signal, or only the Le or Right channels (in mono).