Korg wavestate native - Overview Page

Overview page
17
Overview page
1: Performance Select
6: Mod Knob
Mode
2: Wave Sequence Select 3: Master Lane Progress Bar
5: Mod
Inspector
4: Program Eects
8: Program
Parameters
7: Wave
Sequence
Overview
9: Program
Select
1: Performance Select
is shows the currently selected Performance. Use the < and > arrows to step through Performances one by one,
or click on the name to bring up a browser window. Right-click/control-click (macOS) on the name to bring up a
contextual menu for saving and renaming. For more information, see “1: Performance Select” on page 3, and
“Structure” on page 2.
2: Wave Sequence Select
is is the Program’s Wave Sequence. (If the Wave Sequence page Mode parameter is set to Single Multisample, the
Multisample is shown here instead.) Use the < and > arrows to step through Wave Sequences one by one, or click on the
name to bring up a browser window. Right-click/control-click (macOS) on the name to bring up a contextual menu for
saving and renaming.
3. Master Lane Progress Bar
When enabled, the Master Lane restarts all of the other Lanes aer either a specied number of beats or elapsed time;
see “Master Lane” on page 31. is progress bar shows its current state.
4: Program Eects
is section shows an overview of the Program’s three eects. For detailed editing, see “Eects page” on page 72.
5: Mod Inspector
You can modulate parameters such as Filter Cuto or eects Wet/Dry directly from the Overview page, without diving
into detailed editing. is shows the modulation routings for the selected parameter. You can add or delete routings
from the list, adjust modulation intensity, and change the selected Mod Sources (including adding a second Mod
Source for routings created by drag-and-drop).