KDS-8-MNGR – Using Embedded Web Pages
Streaming an HDMI Audio Source to Multiple Decoders
To route an HDMI audio source (on a detected encoder) to multiple encoders:
1. In the Menu tabs, select Monitor & Control. The Video page appears.
2. Click HDMI Audio. The HDMI Audio page appears.
3. Click and drag a source button in the transmitter area to a predefined HDMI audio group
or an All button in the receiver area.
4. Release the mouse button.
The routed source name appears below the group name.
The source on the encoder is streamed to multiple decoders.
Stopping an HDMI Audio Source Stream
You may need to stop one or all the video streams coming from a source.
When the HDMI Audio of an encoder is set to “Follow Video in Genlock Mode”, and scaling on
that output has been disabled (Bypass), the audio output on that receiver cannot be stopped
by using this control.
To stop a HDMI audio source stream:
1. In the Menu tabs, select Monitor & Control. The Video page appears.
2. Click HDMI Audio. The HDMI Audio page appears.
3. Click and drag an HDMI audio source button (or the All button) to the Stop button in the
transmitter area. Streaming from that source stops.
Source/s streaming has stopped.
Stopping an HDMI Audio Display Stream
To stop an HDMI audio stream on a display:
1. In the Menu tabs, select Monitor & Control. The Video page appears.
2. Click HDMI Audio. The HDMI Audio page appears.
3. Click and drag the display to the Stop button.
4. Release the mouse. Streaming to that display stops.
Drag All button down to the Stop button to stop all streaming.
Display streaming has stopped.
To Next Page
Loading...
Need help?
General