Kramer KT-2010

Kramer Electronics Ltd.
KT-2010 / KT-2010WM – Contents
12
Connecting Options
You can power the KT-2010 or KT-2010WM using any or all of the following options:
1. Connect the PoE-enabled LAN RJ-45 connector to your local area PoE-enabled network.
2. Connect the power adapter to the 12V DC connector on the rear side. The DC power supply
is optional: It can be purchased separately.
When both PoE and the power supply are connected to the Touch Panel, the unit is
powered by the power supply.
3. Use the internal battery (after initially charging the battery for 8 hours).
Figure 5: Powering the Touch Panel