Kramer SL-280 - Page 50

Kramer Electronics Ltd.
SL-280 – Protocol 3000
48
ETH-TUNNEL
Functions
Permission
Transparency
Set:
-
-
-
Get:
ETH-TUNNEL?
Administrator
Internal
Description
Syntax
Set:
Get:
Get parameters for open
tunnels
#ETH-TUNNEL?␠TunnelId␍
Response
~nn@ETH-TUNNEL␠TunnelId,ComNum,PortType,EthPort,EthIp,RemotPort,
ETH_rep_en,Wired
␍␊
Parameters
TunnelId – tunnel ID number :* (get all open tunnels), or type a number corresponding to one of the
existing tunnels
ComNum – SERIAL port number: 1–8
PortType – 1 (UDP), 2 (TCP)
ETHPort – TCP/UDP port number: default = 5001–5008
EthIp – client IP address in the following format: xxx.xxx.xxx.xxx
RemotPort – remote port number
ETH_rep_en – 1 (COM port sends replies to new clients) 0 (COM port does not send replies to new clients)
Wired –
1
(wired connection),
0
(not wired connection)
Response Triggers
Notes
Example
Get parameters for all open tunnels:
#ETH-TUNNEL? *<CR>
Get parameters for tunnel 1:
#ETH-TUNNEL?
1
<CR>