Kramer SL-280 - Page 49

Kramer Electronics Ltd.
SL-280 – Protocol 3000
47
COM-ROUTE-ADD
Functions
Permission
Transparency
Set:
COM-ROUTE-ADD
Administrator
Internal
Get:
-
-
-
Description
Syntax
Set:
Add a communication
route tunnel connection
#COM-ROUTE-ADD␠
ComNum,PortType,EthPort,EthRepEn,Timeout
␍
Get:
-
-
Response
~nn
@COM-ROUTE-ADD␠
ComNum,PortType,EthPort,EthRepEn,TCP_keep_alive_timing
␍␊
Parameters
COM_Num – SERIAL port number: 1–8
portType – 1 (UDP), 2 (TCP)
ETHPort – TCP/UDP port number: default = 5001–5008
ETH_rep_en – 1 (COM port sends replies to new clients) 0 (COM port does not send replies to new clients)
TCP_keep_alive_timing – every x seconds the device sends an empty string to TCP client ("/0"):
0
–
3600
seconds
Response Triggers
Notes
Example
Add a communication route tunnel connection through SERIAL port number 1and TCP port number 5025,
COM port sends replies to new clients and the device sends a keep alive signal every 10 minutes (600
seconds):
#COM-ROUTE-ADD
1,TCP,5025,1,600
<CR>
COM-ROUTE-REMOVE
Functions
Permission
Transparency
Set:
COM-ROUTE-REMOVE
Administrator
Internal
Get:
-
-
-
Description
Syntax
Set:
Remove a
communication route
tunnel connection
#COM-ROUTE-REMOVE␠ComNum␍
Get:
-
-
Response
~nn
@COM-ROUTE-REMOVE␠
Com_Num
␍␊
Parameters
Com_Num
– SERIAL port number: 1–8
Response Triggers
Notes
Example
Remove communication route tunnel connection from SERIAL port number 3:
#COM-ROUTE-REMOVE
3
<CR>