Kramer SL-280 - Page 55

Kramer Electronics Ltd.
SL-280 – Protocol 3000
53
IR-STOP
Functions
Permission
Transparency
Set:
IR-STOP
End User
Public
Get:
-
-
-
Description
Syntax
Set:
Send IR stop
command to port
#
IR-STOP
␠PortNum,Cmd_id,CmdName␍
Get:
-
-
Response
~nn
@IR-STOP␠
PortNum,Cmd_id,CmdName,Status
␍␊
Parameters
PortNum
– IR port transmitting the command:
1
–
8
, * (broadcast to all ports)
Cmd_id – command ID, numeric string of up to 9 digits for flow control and response commands from
device
CmdName – command name, string of up to 15 alpha-numeric characters
Status –
0
(no error)
Response Triggers
Notes
Example
Send IR stop command for IR port number 1, for PowerTog command with ID of 25:
#IR-STOP 1,25,PowerTog<CR>
RELAY-STATE
Functions
Permission
Transparency
Set:
RELAY-STATE
End User
Public
Get:
RELAY-STATE?
End User
Public
Description
Syntax
Set: Set relay state
#RELAY-STATE␠
RelayNumber,RelayState
␍
Get: Get relay state
#RELAY-STATE?␠
RelayNumber
␍
Response
~nn
@RELAY-STATE␠
RelayNum,RelayState
␍␊
Parameters
RelayNumber – Relay port number: 1–8
RelayState – relay state:
0
(open),
1
(closed), see note
Response Triggers
Notes
When relays 1 and 5 are connected as NC (Normally Closed) (see Connecting the Relay Ports on page 8),
the RelayState parameter is reversed:
0
(closed),
1
(open).
Example
Set Relay port number 2 state to closed:
#RELAY-STATE
2,1<CR>