Kramer VP-550X - Page 18

Kramer Electronics Ltd.
VP-550X - Operating and Controlling VP-550X
16
Setting Sleep Mode
VP-550X enables configuring when a connected display enters sleep mode using the Auto
Sync Off feature. Auto Sync Off turns off the output after a period of not detecting a valid
video signal on the input(s) until a valid input is again detected or any keypad button is
pressed.
To set the Auto Sync Off:
1. On the front panel press MENU. The menu appears.
2. Select ADVANCED > Enter, and select Auto Sync Off.
3. Define Auto Sync Off based on the information in this table:
Menu Item
Function
Disable (default)
To always leave the outputs active.
Slow
To disable the outputs after ~ 2 minutes of no input detection.
Fast
To disable the outputs after ~ 10 seconds of no input detection.
Immediate
To disable the outputs ~ 0.5 seconds after detecting a loss of input
signal.
Sleep mode is set.
Setting Switching Mode
VP-550X enables configuring automatic switching of the input source upon signal loss or
when a source is plugged in.
To set the switching mode:
1. On the front panel press MENU. The menu appears.
2. Select Advanced > Enter, and select Auto Switching.
3. Select the switching mode based on the information in this table:
Menu Item
Function
Off (default)
For manual switching.
Auto Scan
Scans for a valid input when no signal is found on the selected input.
Last Connected
Automatically switches to the last connected input and reverts back
to the previously selected input after that input is lost.