VP-550X - Using the Embedded Webpages
Soft Factory Reset
To reset the device to its factory default parameters (as in resetting all parameters
except for the Ethernet parameters):
1. In the Navigation pane, click Device Settings. The Device Settings page appears.
2. Click Soft Factory reset the following message appears:
Figure 19: Device Settings Page – Factory Reset Message
3. Click OK and wait for the webpage to reload following factory reset.
Soft Factory Reset is complete.
See Default Communication Parameters on page 51 to view other factory reset procedures.
Changing Output Settings
VP-550X enables performing the following functions on the outputs:
• Selecting Resolution on page 31.
• Setting Image Size on the Display on page 31.
• Setting Bypass Mode on page 32.
• Adjusting the Picture on page 32.
• Finetuning the Image on page 32.
To Next Page
Loading...
