2. Click Change Adapter Settings.
3. Highlight the network adapter you want to use to connect to the device and click
Change settings of this connection.
The Local Area Connection Properties window for the selected network adapter appears
as shown in Figure 9.
Figure 9: Local Area Connection Properties Window
4. Highlight either Internet Protocol Version 6 (TCP/IPv6) or Internet Protocol Version
4 (TCP/IPv4) depending on the requirements of your IT system.
5. Click Properties.
The Internet Protocol Properties window relevant to your IT system appears as shown in
Figure 10 or Figure 11.
Figure 10: Internet Protocol Version 4 Properties Window
To Next Page
Loading...
