VS-211XS, VS-411XS – Using Embedded Web Pages
Setting Output Audio Source for De-embedded Audio
2-channels of non-encrypted output HDMI audio are de-embedded and are output to the
AUDIO OUT .
To set output audio source:
1. In the Navigation pane, click Video & Audio Settings.
2. Next to De-embedded audio output, click one of the following:
▪ Forward (default), to output audio of the switched HDMI input, forward to the display.
▪ ARC, to output HDMI ARC (Audio Return Channel) audio, returned backwards from
the display.
Figure 33: Video & Audio Settings – Audio ARC
• ARC signal passes between the output display and the switched input source (excluding
VS-411XS IN 4).
• The audio source is output to the speakers connected to AUDIO OUT in parallel to its traversal
to/from the display.
Output audio source is set.
Setting HDCP Support
There are video sources (e.g., some Apple devices) that automatically switch to HDCP
protected mode if connected to a device that supports HDCP (e.g. VS-411XS) protection. You
can set HDCP support modes on both the inputs and the output.
For example, if an acceptor connected to VS-411XS output does not support HDCP
protection, you might want to disable input HDCP support, so that the video source does not
auto-switch to HDCP-protected mode and driving no video display on the output acceptor.
Other HDCP support options are available, allowing flexible support according to HDCP
compatibility needs between the input sources and output acceptor.
To Next Page
Loading...
