Changing TCP/UDP Port Numbers
By default, TCP/UDP port numbers are set to 5000/50000 respectively.
To change the port numbers:
1. Click Device Settings on the Navigation List (Figure 22).
2. Select Communication tab.
3. Enter the new port number or use the up/down arrows to set the new port number.
4. Click Set.
Port numbers have changed.
Define CEC Gateway Settings
VS-411XS built-in CEC gateway enables IP control of control system, via CEC messages, on
HDMI connected devices to the selected input and the output port (see IP-Driven CEC
Signals Routing via Built-in Control Gateway on page 11). The Members address list shows
the logical addresses of connected CEC-enabled devices.
To disable CEC gateway feature:
1. Click Device Settings on the Navigation List (Figure 22).
2. Select Communication tab.
3. Click CEC gateway OFF.
CEC gateway is disabled.
You can view the logical addresses of CEC-enabled devices that are connected via HDMI
output port to VS-411XS and click Refresh to refresh the list.
To Next Page
Loading...
