Kramer VS-411XS - Auto Switching Priorities; Input Color Depth

Kramer Electronics Ltd.
VS-211XS, VS-411XS – Using Embedded Web Pages
34
Setting Auto Switching Priorities
By default, VS-411XS is set via the SETUP DIP-switches (see Setting DIP-Switches
on page 15) to auto-switching, last-connected switching mode. You can view current
switching mode and change switching priorities (applicable to Priority mode only) via the
embedded web pages.
To change switching priorities:
1. In the Navigation pane, click Video & Audio Settings.
2. View the video selection mode.
3. Drag and drop inputs to set which inputs get higher priority.
Figure 31: Dragging Input to Change Priority
The video inputs priority changes.
Setting Input Color Depth
VS-411XS enables setting the color depth per input.
To Set the Color Depth on an input:
1. In the Navigation pane, click Video & Audio Settings.
2. Next to each input, click one of the following:
▪ Follow Output (default), to follow the output color depth.
▪ Force 8-bit color graphics.
Figure 32: Video & Audio Settings – Color Depth
Color Depth is defined.