Setting Video Signal Timeouts
VS-411XS enables setting the time delay before triggering auto-switching and display
auto-sleep entry.
To set the timeout for auto-switching video inputs if signal is lost:
1. In the Navigation pane, click Video & Audio Settings.
2. Under “When the HDMI signal is lost, leave 5V power ON and delay switching for"
set the delay time 0-905 seconds (where 0 is no timeout, 10 is the default).
Figure 35: Video & Audio Settings – Timeouts
3. Click Set Timeout.
Auto-switching on signal-lost timeout is set.
To set the timeout for auto-switching video inputs for unplugged HDMI cable:
1. In the Navigation pane, click Video & Audio Settings.
2. Under “When the HDMI cable is unplugged, delay switching for"
set the delay time 0-905 seconds (where 0 is no timeout and the default).
3. Click Set Timeout.
Auto-switching on cable-unplug timeout is set.
To Next Page
Loading...
