Kramer VS-411XS - Operating and Controlling VS-411 XS; Front Panel Buttons; DIP-Switches

Kramer Electronics Ltd.
VS-211XS, VS-411XS – Operating and Controlling VS-411XS
15
Operating and Controlling
VS-411XS
Using Front Panel Buttons
Use the front panel to control VS-411XS. Press:
• IN buttons to select an input.
• VOL buttons to increase or decrease the buttons.
• MUTE to mute/unmute the audio output.
Setting DIP-Switches
The 4 DIP-switches located on the front panel are used for setting the switching mode and
for CEC notifications.
Figure 11: SETUP DIP-switches
All DIP-switches are set to Off (up) by default. DIP-switch changes take effect immediately.
#
Feature
Dip-Switch Settings
1
Switching
Mode
OFF (up) – Auto-switching mode.
ON (down) – Manual mode.
2
Auto-switching
Mode
OFF (up) – Last connected switching mode: the last detected active source is
auto-switched to the output.
ON (down) – Priority switching mode: the device switches the source with the
highest priority to the output.
3
CEC
Notifications
OFF (up) – CEC notifications enabled.
ON (down) – CEC notifications disabled.
4
Reserved for
Factory Use
It is mandatory to keep set to OFF (up).
2
3
1