SAFETY INSTRUCTIONS 1
5
OPTIMASS 3000
www.krohne.com10/2015 - 4001593002 - MA OPTIMASS 3000 R02 en
Safety instructions
1.1 Software history
1.2 Intended use
This mass flowmeter is designed for the direct measurement of mass flow rate, product density
and product temperature. Indirectly, it also enables the measurement of parameters like total
mass, concentration of dissolved substances and the volume flow. For use in hazardous areas,
special codes and regulations are also applicable and these are specified in a separate
documentation.
1.3 CE certification
This device conforms with the following EC directives:
• EMC Directive 2004/108/EC
• ATEX Directive 94/9/EC
• Low Voltage Directive 2006/95/EC
• Pressure Equipment Directive 97/23/EC
The manufacturer declares conformity and the device carries the CE mark.
Release date Software version Documentation
Aug 2008 V2.2.xx MA MFC 300 R02
MA OPTIMASS 3000 R02
CAUTION!
Responsibility for the use of the measuring devices with regard to suitability, intended use and
corrosion resistance of the used materials against the measured fluid lies solely with the
operator.
INFORMATION!
This device is a Group 1, Class A device as specified within CISPR11:2009. It is intended for use in
industrial environment. There may be potential difficulties in ensuring electromagnetic
compatibility in other environments, due to conducted as well as radiated disturbances.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
CE marking
MA_OPTIMASS_3000_en_151014_4001593002_R02.book Page 5 Wednesday, October 14, 2015 1:20 PM
To Next Page
Loading...
Need help?
General
