Krone Comprima V 180 XC - Setting of the Baling Pressure Display (Medium Electronic System)

Operation
148
Pos: 48.89 /Übersc hriften/Überschrif ten 2/A-E/ E/Einstellung Pres sdruckanzeig er (Alpha - Me diumele ktronik) @ 85\mod_1 31909841560 8_78.docx @ 7 37073 @ 2 @ 1
11.15 Setting of the Baling Pressure Display (Medium Electronic System)
Pos: 48.90 /BA/Ei nstellungen/Ru ndballenpresse/Pr essdruck/Ei nstellung des Pressdrucka nzeigers (Mediu m) @ 85\mod_1 31909563087 6_78.docx @ 7 37015 @ @ 1
COMPRIMA F 125 (XC)
COMPRIMA F 155 (XC)
13
2
1
3
COM00017
2
20
4
4
30
Fig.
119
Adapt the upper baling pressure indicator to the lower baling pressure indicator via the cable
adjustment (3), if the tension levers left/right (1) are adjusted correctly (refer to chapter
Operation “Tighten the floor conveyor and set the spring pretensioning”).
If the bales are still formed conically after the adjustment, proceed as follows:
1. Raise the tension levers on the left/right (1) 20 mm (Comprima F 125 (XC)) and 30 mm
(Comprima F 155 (XC) each from the stop (2).
2. In this position, adjust the upper baling pressure indicator to the lower baling pressure
indicator via the cable adjustment (3).
Pos: 48.91 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1