Krone Comprima V 180 XC - Adjusting the Automatic Blocking Time; Adjusting the Engine Position (Net)

KRONE Operation Unit Alpha
96
Pos: 42.28 /Übersc hriften/Überschrif ten 4/A-E/ Einstellen der Automatik-Sperr zeit @ 82\m od_1317031781 459_78.doc x @ 725093 @ 4 @ 1
8.1.6.2 Adjusting the Automatic Blocking Time
Pos: 42.29 /WHB/ Elektrik/Rundballe npresse/Alph a (Medium)/Ei nstellungen un d Diagnose @ 8 2\mod_13 17031393670_7 8.docx @ 725 038 @ @ 1
The automatic blocking time determines the time in which the automatic knotter triggering is
locked. The automatic blocking time starts the first time with switching on the operation. The
automatic blocking time starts then with the end of the last tying process and ends with the
preselected blocking period.
AB CD EF GH
2
3
6
7
8
10
RPM00016
Fig.
69
1. When switching operation on, keep the key pressed.
The pilot lamp for type of tying “Net” (4) lights up.
2. Use the or key to increase or reduce the Automatic Blocking Time.
The set value can be read off on the bar graph.
A
B
C
D
E
F
G
H
Seconds
10
20
30
40
50
60
70
80
3. The value is saved by using key.
The pilot lamp for “Start Tying” (10) lights up briefly.
Pos: 42.30 /Übersc hriften/Überschrif ten 4/A-E/ Einstellung d er Motorposition (N etz) @ 83\mo d_131711583 4574_78.docx @ 726950 @ 4 @ 1
8.1.6.3 Adjusting the Engine Position (Net)
Pos: 42.31 /WHB/ Elektri k/Rundballenpresse/Alp ha (Medium) /Einstellung der M otorposition (N etz) @ 82\ mod_1317031 936802_78.docx @ 725120 @ @ 1
The feed and cut-off position is approached and stored here.
1. When switching operation on, keep the key pressed.
The pilot lamp for type of tying “Twine” (5) flashes slowly.
The pilot lamp for type of tying “Net” (4) lights up.
Pos: 42.32 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1