Krone Comprima V 180 XC - Menu 1 Number of Film Layers (Chamber Film Wrapping); Menu 2 Number of Twine Layers (Twine Tying)

Terminal menus 7
Menu 1 “Number of film layers” (chamber film wrapping) 7.9
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 41
7.9 Menu 1 “Number of film layers” (chamber film wrapping)
n
1
5,0
1,5
3.5
n
EQG003-001
ü For The menu level is active, refer to page36.
ü Chamber film wrapping is selected in menu 8 “Type of tying”, refer to page48.
 To open the menu, press
n
.
Æ The display shows menu "Number of film layers".
Adjusting the number of film layers
 Increase or decrease the value, refer to page37.
 To save the value, press
.
INFORMATION
KRONE recommends 3.5 – 4 film layers for optimum chamber film wrapping. The minimum
required film layers depend on the condition of the crops.
With round bales whose diameter measures more than 130cm and/or very dry or very wet
crops, KRONE recommends at least one additional film layer.
7.10 Menu 2 "Number of twine layers" (twine tying)
This menu is used to set
• how many twine layers are to be tied around the round bale at the start of twine tying before
the twine guide slide starts up and
• how many twine layers are to be tied around the round bale at the end of twine tying before
the twine is cut off.
When setting the number of twine layers around the entire round bale, see chapter Operation,
Twine tying, "Setting the number of twine layers".