Krone Comprima V 180 XC - Adjusting the Twine Limiter

Settings
194
Pos: 50.7 /Übersc hriften/Übersc hriften 2/F-J/G /Garnbegrenzer einstellen @ 3 44\mod_1433 254632758_7 8.docx @ 2598 567 @ 2 @ 1
12.9 Adjusting the twine limiter
Pos: 50.8 /Übersc hriften/Zwisc henüberschriften/A -E/Bei Ausfü hrung Garn- und Netzbindung @ 335\mod _1429618464750 _78.docx @ 2552971 @ @ 1
With twine tying and net tying version
Pos: 50.9 /BA/Bedi enung /Run dballenpresse/Gar nbegrenzer ei nstellen_Einleit ung @ 344\m od_14332496 42693_78.doc x @ 2598470 @ @ 1
The position of the twine limiter determines the distance from outermost wrapping to the outside
edge of the bale.
The setting is made depending on length and type of crop to avoid that the twine slips off the
round bale twine.
Pos: 50.10 /BA/Be dienung /Ru ndballenpresse/N etz-Garnbind ung/Bild Garn begrenzer_Co mprima @ 345\ mod_14341101 82790_78.doc x @ 2606893 @ @ 1
X
2
1
1
2
Fig.
163
Pos: 50.11 /BA/Be dienung /Ru ndballenpresse/N etz-Garnbind ung/Tabelle Garn begrenzer _Comprima @ 34 5\mod_143411 0025063_78.d ocx @ 260686 2 @ @ 1
Length of crop material
Distance x between the two twine limiters
Short
Narrow
Medium
Medium
Long
Wide
Pos: 50.12 /BA/Be dienung /Ru ndballenpresse/G arnbindung Co mprima/Fadenb egrenzer ei nstellen_Text_C omprima @ 34 3\mod_14331 59142314_78.d ocx @ 259476 3 @ @ 1
• Loosen the screws (2) on the left and right side.
• Slide the twine limiter (1) on the left and right side to the desired position in the direction of
the arrow.
Make sure that the twine limiter has the same setting on the left and right.
• Tighten the screws (2) on the left and right side.
Pos: 50.13 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1