Krone Comprima V 180 XC - Page 193

Settings
193
Pos: 50.5.57.8 /Ü berschriften/Zwis chenüberschrift en/A-E/En dposition prüfe n und einstellen @ 399\mod _1447255951304_ 78.docx @ 28 29240 @ @ 1
Checking and setting end position
Pos: 50.5.57.9 /B eipacks/Rundb allenpressen/Foli enbindung/Mo dulgruppen Br emse / Spiral walze/Endposition prüfen und ei nstellen_Bild @ 399\mod_1 44725585628 9_78.docx @ 28 29179 @ @ 1
COM00442
1
2
3
Fig.
162
Pos: 50.5.57.10 / Beipacks/Rund ballenpressen/F olienbindung/M odulgruppen Br emse / Spiral walze/Endpositio n prüfen und eins tellen_T ext_alle Compri ma @ 513\mod _1503395095 889_78.doc x @ 3529418 @ @ 1
For the chamber film wrapping version, the feed rocker arm (1) in its limit position must lie
against the insulation of the pressure axis (2). For optimum film reception, check the limit
position and adjust if necessary:
• Open menu 10 "Manual operation" in the terminal.
• Move the feed rocker arm (1) with the terminal to the saved limit position.
• Switch the tractor off and remove the ignition key.
• Check whether the deflection roll (3) lies against the insulation of the pressure axis (2) and
the film is clamped between the insulation of the pressure axis (2) and the deflection roll (3).
If not:
• Start the tractor.
• Open menu 15-1 "Sensor test" in the terminal.
• Keep the key pressed until the deflection roll (3) lies against the insulation of the
pressure axis (2) and the film is clamped between the insulation of the pressure axis (2) and
the deflection roll (3).
• Select the key.
The set position is saved. The icon in the top line appears.
Pos: 50.6 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_119617 5311226_0.docx @ 4165 @ @ 1