Krone Comprima V 180 XC - Page 172

Operation
172
Pos: 48.112.8 /Ü berschriften/Z wischenüberschrift en/A-E/Dop pelschwinge ein stellen_Ballen kern @ 468\ mod_1469601218 962_78.doc x @ 3154872 @ @ 1
Setting the double rocker arm
Pos: 48.112.9 / BA/Bedienung /R undballenpresse/Di chte des Ballenkerns einstellen_Compri ma V_CV_+X- treme/Doppelsch winge einst ellen_bild_Compri ma V @ 467\ mod_146910 5051239_78.doc x @ 3151252 @ @ 1
VPN00012
4
5
6
Fig.
144
Sample illustration (Comprima V 180)
Pos: 48.112.10 /B A/Bedienung /Ru ndballenpress e/Weichkern an passen_Com prima V_CV_+X- treme/Do ppelschwinge einstellen_text @ 467\mod_146 9018850269_7 8.docx @ 31 50044 @ @ 1
If the lower stop of the double rocker arm (4) is set, the compression path is reduced or
extended and the bale core becomes harder or softer.
On the right and left sides of the machine:
• Unscrew the screw (5).
• Move the stop (6) to the right or left by one borehole into the next position (I), (II) or (III).
The 3 positions are explained in more detail below.
• Mount the screw (5).
• Ensure that the stop (6) is set the same on the right and left machine side.
Pos: 48.112.11 /B A/Bedienung /Ru ndballenpress e/Dichte des B allenkerns einst ellen_Com prima V_CV_+X-tr eme/Positi onen Ballenkern _einleitung-te xt_Comprima V @ 467\mod_14 69104528217 _78.docx @ 3151 221 @ @ 1
To alter the density of the bale core, you can set the following positions. For example, the
Comprima V 180 is shown.
Pos: 48.112.12 /B A/Bedienung /Ru ndballenpress e/Dichte des B allenkerns einst ellen_Comprim a V_CV_+X-tr eme/Positi onen Ballenkern _bilder+text_C omprima V_CV @ 467\mod_14 69021016512 _78.docx @ 3150267 @ @ 1
COM00461
1
I
Fig.
145
Position I of the screw
High bale core density
1 notch at the top (1)