Terminal menus 7
Menu 15 "Settings" 7.25
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 65
Setting the feed position
RP000-043
The distance (X) between the pivot point of the ratchet mechanism (1) and the adjusting lever
(2) must be X=285–295mm.
With net and chamber film wrapping, the feed position has been optimally set if the feed rocker
arm moves as close as possible to the stop to ensure the distance is 5 mm, see chapter
Chamber film wrapping, “Checking and setting the feed position”.
With net wrapping: Press the key
or until the tying actuator extends far enough
and the dimension is X=285–295mm.
Press
.
Æ The set position is saved.
Setting the cutting position
RP000-044
The cutting position has been optimally set when the dimensions are as follows with raised
ratchet mechanism (1):
To Next Page
Loading...
