Malfunctions - Causes and Remedies
103
Pos: 48.5 /BA/St örungen - Ursac hen und Behebu ng/Schwader/T abellarische Auflis tung Schw ader 1000 @ 2\ mod_1202993 666593_78.doc x@ 64241 @ @ 1
Malfunction Possible cause Remedy
Rotor does not operate smoothly Raking height set too high Set raking height lower
Working speed is too high. Reduce drive speed. Reference
values 8-10 km/h. In the case of
uneven terrain, high forage
quantities, drive slower if required.
Speed too low Increase the speed. Standard
value 450 rpm
Sideward inclindation of rotors
incorrectly set
Change sideward inclination (see
Chapter "Sideward inclination of
rotor running gear").
Tine arm(s) crooked Replace tine arms
High forage contamination Raking height set too low Set raking height higher
Tine arm(s) bent Replace tine arms
Swath width too large Working width too great Change working width
Speed too low Increase the speed.
Rotor unable to adjust to ground
unevenness.
Suspension arms of tractor set
too high or too low
Adjust frame horizontally (height
of steerable pinions approx. 63
cm)
Rotor is not in flow position.
By pressing the key, bring
rotor in flow position.
Setting raking height - does not
function electrically
Fuse defective
Replace protection in switch box
which is screwed onto frame.
Rotors cannot be moved out of
headland into working position by
pressing the key.
Minimum swath width not
reached.
Move rotor into transport position
and swivel down once again.
Swath width sensor defective. Check the sensor and replace it, if
and when necessary.
Rotor arm sensor defective. Check the sensor and replace it, if
and when necessary.
Pos: 49 /BA/----- ---------- Seitenumbruch------ ---------- @ 0\mod_1 19617531122 6_0.docx @ 41 65@ @ 1
To Next Page
Loading...
