Krone Swadro 1000 - Adjusting the Sensors

Maintenance
83
Pos: 42.34 /Übersc hriften/Überschrif ten 3/A-E/Ein stellung der S ensoren @ 0\mo d_119996217 3428_78.docx @ 37635 @ 3 @ 1
11.10.1 Adjusting the Sensors
Pos: 42.35 /BA/ Wartung/Sensor en/Namursensor d= 30 m m a=5 mm @ 0\mo d_119996252 0100_78.docx @ 37673 @ 4 @ 1
11.10.1.1 Namur sensor d = 30 mm
a
BPXC0172
2
1
3
Figure 51
The dimension between the encoder (2) and the sensor (1) must be "a" = 5 mm .
Setting
• Loosen the nuts on either side of the sensor.
• Turn the nuts until dimension "a" = 5 mm is reached.
• Tighten the nuts again.
Pos: 42.36 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ @ 1