KSB CTN - Returning to Service

6 Commissioning/Start-up/Shutdown
37 of 76
CTN / CTN-H
If the pump set is to be stored temporarily, only preserve the wetted components
made of low alloy materials. Commercially available preservatives can be used for this
purpose. Observe the manufacturer's instructions for application/removal.
Observe any additional instructions and information provided. (ðSection3,Page13)
6.4 Returning to service
For returning the equipment to service observe the sections on commissioning/start-
up and the operating limits. (ðSection6.1,Page27) (ðSection6.2,Page34)
In addition, carry out all servicing/maintenance operations before returning the
pump (set) to service. (ðSection7,Page38)
WARNING
Failure to re-install or re-activate protective devices
Risk of injury from moving parts or escaping fluid!
▷ As soon as the work is completed, properly re-install and re-activate any safety-
relevant devices and protective devices.
NOTE
If the equipment has been out of service for more than one year, replace all
elastomer seals.