14 BRAKE SYSTEM 131
Info
After the ignition is switched back on, ABS is enabled again.
14.2 Checking the brake discs
Warning
Danger of accidents Reduced braking efficiency due to worn brake disc(s).
– Change the worn brake disc(s) without delay. (Your authorized KTM workshop will be glad to help.)
400618-10
– Check the thickness of the front and rear brake discs at multiple points on each brake
disc to ensure it is at least thickness
A
.
Info
Wear will reduce the thickness of the brake disc at the contact surface
1
of
the brake linings.
Brake discs - wear limit
Front 4 mm (0.16 in)
Rear 4.5 mm (0.177 in)
» If the brake disc thickness is less than the specified value.
– Change the brake disc.
– Check the front and rear brake discs for damage, cracking, and deformation.
» If the brake disc exhibits damage, cracking, or deformation:
– Change the brake disc.
To Next Page
Loading...
