KTM 2014 1190 Adventure User Manual

16 ELECTRICAL SYSTEM 168
– Check the headlight setting. ( p. 172)
16.9 Changing the low beam bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the passenger seat. ( p. 103)
– Remove the driver's seat. ( p. 104)
– Remove the front side cover. ( p. 116)
– Remove the tank cover. ( p. 124)
–
Remove the mask spoiler. x ( p. 118)
– Remove the wind shield. ( p. 127)
– Remove the headlight mask with the headlight. ( p. 165)
S00297-10
Main work
–
Push headlight bulb
1
lightly into the bulb socket, turn it all the way counterclock-
wise, and pull it out.
–
Disconnect plug
2
.

KTM 2014 1190 Adventure Specifications

General

Engine Type	2-cylinder, 4-stroke, V 75°
Displacement	1195 cc
Bore x Stroke	105 mm x 69 mm
Compression Ratio	12.5:1
Torque	125 Nm @ 7500 rpm
Fuel System	Electronic Fuel Injection
Transmission	6-speed
Frame	Chromium-Molybdenum steel trellis frame, powder coated
Front Suspension	WP USD Ø 48 mm
Front Tire	120/70 ZR 19
Rear Tire	170/60 ZR 17
Dry Weight	217 kg
Fuel Capacity	23 liters
Power	150 hp (110 kW) @ 9500 rpm
Clutch	PASC slipper clutch, hydraulically operated
Front Brake	2 x Brembo 320 mm discs, 4-piston radial calipers
Rear Brake	Brembo 267 mm disc, 2-piston caliper
ABS	Bosch 9ME Combined ABS
Seat Height	860 mm