11 SERVICE WORK ON THE CHASSIS
42
11.1 Raising the motorcycle with a lift stand
Note
Danger of damage The parked vehicle can roll away or fall over.
– Park the vehicle on a firm and level surface.
401942-01
– Raise the motorcycle at the frame underneath the engine.
Lift stand (78129955100)
Neither wheel is in contact with the ground.
– Secure the motorcycle against falling over.
11.2 Removing the motorcycle from the lift stand
Note
Material damage The vehicle may be damaged by incorrect procedure when parking.
Significant damage may be caused if the vehicle rolls away or falls over.
The components for parking the vehicle are designed only for the weight of the vehicle.
– Park the vehicle on a firm and level surface.
– Ensure that nobody sits on the vehicle when the vehicle is parked on a stand.
402001-10
– Remove the motorcycle from the lift stand.
– Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
1
into the left
side of the wheel spindle.
Info
Remove the plug-in stand before riding.
11.3 Bleeding the fork legs
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 42)
H01182-12
Main work
–
Release bleeder screws
1
.
Any excess pressure escapes from the interior of the fork.
–
Tighten the bleeder screws.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 42)
To Next Page
Loading...
