BRAKE SYSTEM 12
83
F00406-10
–
Insert the new brake linings, insert pin
4
, and mount cotter
pins
3
.
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
7
is mounted on the
piston side brake lining.
– Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
K01106-10
–
Add brake fluid to level
A
.
Brake fluid DOT 4 / DOT 5.1 ( p. 126)
–
Mount and tighten screw cap
1
with membrane
2
and the
O-ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
To Next Page
Loading...
