KTR ROTEX GS - 2.3 Safety and Advice Hints; 2.4 General Hint to Danger; 2.5 Proper Use

KTR Kupplungstechnik
GmbH
D-48407 Rheine
ROTEX
®
GS
Operating/mounting instructions
KTR-N
Sheet:
Edition:
45510 EN
15of36
15
Please note protection
mark ISO 16016.
Drawn: 15.10.12 Pz Replaced for: KTR-N valid from 08.02.12
Verified: 29.10.12 Pz Replaced by:
2 Hin
ts
2.3 Safety and Advice Hints
STOP
D A N G E R ! Danger of injury to persons
!
C A U T I O N ! Damages on the machine possible

AT T E N T I O N ! Pointing to important items
P R E C A U T I O N ! Pointing to explosion-proof applications
2.4
General Hint to
Danger
STOP
D A N G E R !
With the assembly, operation and maintenance of the coupling it has to be made sure that
the entire drive train is protected against unintentional engagement. You may be seriously
hurt by rotating parts. Please make absolutely sure to read through and observe the
following safety instructions.
• All operations on and with the coupling have to be performed taking into account „safety first“.
• Please make sure to disengage the power pack before you perform your work on the coupling.
• Protect the power pack against unintentional engagement, e. g. by providing hints at the place of engagement
or removing the fuse for current supply.
• Do not touch the operation area of the coupling as long as it is in operation.
• Please protect the coupling against unintentional touch. Please provide for the necessary protection devices
and caps.
2.5
Proper Use
You may only assemble, operate and maintain the coupling if you
• have carefully read through the mounting instructions and understood them
• had technical training
• are authorized to do so by your company
The coupling may only be used in accordance with the technical details (see tables 1 to 11, chapter 1).
Unauthorized modifications on the coupling type are not admissible. We do not take any warranty for resulting
damages. To further develop the product we reserve the right for technical modifications. The ROTEX
®
GS
described in here corresponds to the technical status at the time of printing of these mounting instructions.
3
Storage
The coupling hubs are supplied in preserved condition and can be stored at a dry and roofed place for 6 - 9
months.
The features of the coupling spiders (elastomers) remain unchanged for up to 5 years in case of favourable stock
conditions.
!
C A U T I O N !
The storage rooms may not include any ozone-generating devices, like e. g. fluorescent
light sources, mercury-vapour lamps or electrical high-voltage appliances.
Humid storage rooms are not suitable.
Please make sure that there is no condensation. The best relative air humidity is less than
65%.