25OPERATING THE MACHINE
ENGLISH
A For checking and servicing of your machine, consult
your local KUBOTA Dealer for instructions.
LCD MONITOR
BFuel Gauge
When the key switch is on, the fuel gauge indicates the
fuel level.
Be careful not to empty the fuel tank. Otherwise air may
enter the fuel system.
Should this happen, the system should be bled. (See
"Bleeding Fuel System" in "SERVICE AS REQUIRED" in
"PERIODIC SERVICE" section)
BCoolant Temperature Gauge
To avoid serious injury or death:
A Do not remove radiator cap until coolant
temperature is well below its boiling point.
Then loosen the cap slightly to relieve any
pressure before removing the cap completely.
1. With the key switch "ON", this gauge indicates the
temperature of the coolant. "C" for "cold" and "H" for
"hot".
2. If the indicator reaches the "H" position (red zone),
engine coolant is overheated. Check the machine by
referring to "TROUBLESHOOTING" section.
Glow plug Indicator (Pre-heating Indicator)
When the key switch is in the "PREHEAT"
position, the glow plug indicator illuminates.
(1) LCD monitor
(1) Fuel gauge (A) "EMPTY"
(B) "FULL"
(1) Coolant temperature gauge
To Next Page
Loading...
