Kubota F2890E - Hourmeter; Tachometer; Service Code Display; Overheat Alarm

OPERATING THE MACHINE26
ENGLISH
BHourmeter / Tachometer
This meter gives readings for engine speed and the hours
the machine has been operated.
1. The tachometer indicates the engine speed.
2. The hourmeter indicates in 5 digits the hours the
machine has been used; the last digit indicates 1/10 of
an hour.
BService Code Display
The key switch is on, and if the service code
(" " or " ") shown in the figure
below is displayed on the liquid crystal display, the
servicing tasks corresponding to the indication on hour
meter (displayed at 10 seconds after that) should be
carried out on the machine.
See "SERVICE INTERVALS" in "MAINTENANCE"
section.
BOverheat Alarm
If the temperature of the coolant rises to overheat
temperature, the overheat alarm whistles.
Check the machine by referring to "TROUBLE
SHOOTING" section.
(1) Engine revolution (with an error of 1%)
(2) Hours used
(1) Service code
(2) Hours used
(A) At 10 seconds after the
service code has displayed.