PERIODIC SERVICE44
ENGLISH
BChecking OPC System
The OPC (Operator Presence Control) system in your
machine is designed to protect you while operating.
Check the OPC system periodically. It is recommended to
check the OPC system before daily operation.
To avoid serious injury or death:
A Do not allow anyone near the machine while
testing.
A If the machine does not pass one of the
following tests, do not operate the machine.
See your local KUBOTA Dealer.
A Check the following tests before operating the
machine.
Test 1:
1. Start the engine.
2. Shift the PTO lever to the "DISENGAGE" position.
3. Release the brake pedal.
4. Stand up. (DO NOT GET OFF THE MACHINE.)
5. The engine must shut off.
Test 2:
1. Start the engine.
2. Shift the PTO lever to the "ENGAGE" position.
3. Release the brake pedal.
4. Stand up. (DO NOT GET OFF THE MACHINE.)
5. The engine must shut off.
Test 3:
1. Start the engine.
2. Depress the brake pedal fully and lock the parking
brake.
3. Shift the PTO lever to the "ENGAGE" position.
4. Stand up. (DO NOT GET OFF THE MACHINE.)
5. The engine must shut off.
BLubricating All Grease Fittings
To avoid serious injury or death:
A Be sure to stop the engine and remove the key
before greasing.
Grease the following location.
(1) Brake pedal
(2) PTO lever
(3) Key switch
(4) Throttle lever
(1) Speed control pedal shaft
To Next Page
Loading...
