55PERIODIC SERVICE
ENGLISH
BChanging Rear Axle Gear Case Fluid
[4WD]
(RIGHT AND LEFT) (See "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
1. To check the oil level, remove the check plug (bolt).
A Place the mower on a level surface.
Loosen the check plug. Oil should be visible
through the opening. If the oil level is too low or
high, adjust it.
2. To change gear oil, remove the drain and filling port
plug with the hex head wrench to drain the used oil.
After draining, replace the drain plug and fill with new
oil.
BAdjusting Rear Axle Pivot
If the rear axle pivot pin adjustment is not correct, rear
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, tighten adjusting screw all the way,
and then loosen the screw by 1/6 turn.
Retighten the lock nut.
BReplacing Fuel Filter
Change fuel filter every 400 hours. This should be done by
your local KUBOTA Dealer.
Oil capacity 0.5 L
(1) Filling and checking port plug
(2) Drain plug
(3) Hex head wrench
(1) Adjusting screw
(2) Lock nut
To Next Page
Loading...
