Kubota F2890E - Replacing Light Bulb; Bleeding Fuel System

61PERIODIC SERVICE
ENGLISH
* If fuse No.16 and 17 are equipped,
BReplacing Light Bulb
1. Head light
Take the bulb out of the light body and replace with a
new one.
2. Other lights
Detach the lens and replace the bulb.
BBleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When tank is completely empty.
3. After the machine has not been used for a long period
of time.
C Bleeding procedure is as follows:
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and
then stop the engine.
3. Open the bleed screw.
When bubbles disappear from fuel coming out of the
plug, tighten the bleed screw.
FUSE
No.
CAPACITY
(A)
Protected circuit
15 Flasher unit +B (option)
5 Fuel pump
5 OPC control/rotation sensor
5 Glow plug
20
Combination switch/lamp
(option)
7.5 Brake lamp (option)
10 Flasher unit AC (option)
10 Horn/Head light
10 Spare
15 Spare
5 Spare
Slow blow fuse
50
Check circuit against wrong
battery connection
- Fuse puller
7.5 Spare
15 Work light (option)
7.5 Beacon lamp (option)
Light Capacity
Head light 55 W
Front lamp
Front lamp LH, RH 60 W
Turning lamp LH, RH 21 W
Position lamp LH, RH 21 W
Rear lamp
Brake lamp LH, RH 21 W
Tail lamp LH, RH 5 W
Turning lamp LH, RH 21 W
Number plate lamp 10 W
Beacon lamp 60 W
Work lamp 35 W